| Converter |
Leads and terminals for evidence of overheating or looseness |
Replace leads and or tighten terminal nuts |
|
Mount brackets for security |
Tighten attaching nut |
|
Interior for cleanness |
Clean if required |
|
Fuse holder clips for security |
Tighten if required |
| Batteries |
Terminals for corrosion |
Clean |
|
Compartment cover for damage |
Replace if cover does not seat in mount to provide good seal |
|
Mount tray and hold down brackets for acid damage, excessive dirt or corrosion |
Clean; replace hold down brackets if damage is excessive |
|
Vent caps for damage and proper operation |
Replace |
|
Low electrolyte level |
Replenish |
|
Loose cable clamp at terminal posts |
Tighten |
| Wiring harnesses |
Damaged insulation or wrapping loose at terminal connections |
Tighten |
|
Improper routing |
Reroute and tie in place |
|
Connector plugs for secure mating. |
Fully insert plug prongs into receptacle of mating plug |
